2013-07-18 by seoer3
Diamond Equipment Superfinishing the ferrule channel shows the advantages of weird than corundum processing finish, R arc good shape; than green silicon cutting ability, good wear resistance, both the bearing groove curvature guarantee accuracy. .
Diamond Equipment Superfinishing the ferrule channel shows the advantages of weird than corundum processing finish, R arc good shape; than green silicon cutting ability, good wear resistance, both guarantees the bearing groove curvature, precision, waviness improved to meet the C, D, G-bearing finish requirements, but also to give birth rate doubled progress.
When using
diamond grinding equipment, abrasive grains within the faster formation of small flat or concave, and because of the inherent Diamond Equipment creamy grain before, so that's easy to stick crumbs, so super-lapping and grinding, the stalemate sharp blade the mouth and a high finish.
2013-07-19 by seoer3
Use diamond generally high concentrations, the unit area of the working layer of diamond particles, the more, by the force of each grain is small, the depth of penetration is small, easy to break and fall off the diamond, but is easy to grind and polish, the macro-showed low efficiency, long life; diamond concentration is low, each grain has a greater cut-in pressure, cut deep, Diamond Blades easily broken and fall off, the tool performance, high efficiency, low life. However, if the diamond particles and broken off prematurely, but decreased the efficiency, even work, which in poor quality diamond, binders, especially when the carcass is too wear.
In the case of the same diamond concentration, different size, the particles vary greatly, which may cause the tool to work at the level of diamond particles are very different, and thus the tool life of the processing efficiency, the processing effect is different.
Actual selection of diamond concentration, must be integrated into the quality of the abrasive particle size, binder formulation, construction of the tool, the conditions of use, to be processed material and processing requirements (efficiency, effectiveness, life) and so on. Such as fine particle size, the concentration should be lower; work breadth and profile grinding tools should use high concentrations; roughing tool should concentrations higher; grinding tools, the concentration should be lower.