For woodworking Diamond Cutting Blade use many people have different views as to force its suppliers here we just share with you the correct use of woodworking saw blade . Because only the right to use it , we can better play its service life. 1 When using woodworking saw blade must be stable and not swinging back and forth . And the size of the flange to be consistent , preferably 1 / 3 blade diameter. 2 shaft should be straight and smooth , does not exceed the tolerance H7, washers should be absolutely vertical . 3 blade reamer recommends no more than 20 mm of the original hole , otherwise it will lead to loss of photos you saw blade cutting results will be affected. When grinding the corner and saw the body careful not to manual operation, will result in jagged fragments and saw the body imbalances.  The blade has insensitive , it is timely grinding and keep a jagged original cutting angle . 5 blades should be cleaned before installation , if the saw body sticky with resin , diluted rub need to do . Gangsaw installation, be careful hob and feeding stations were required to the same level . To view the blade before cutting the installed tightened to prevent slipping on the shaft blade . Just do when using woodworking saw blade over five points , then the blade will improve your product quality , shorten the processing cycle , reduce your processing costs. In this warm and remind you also have a lot of different woodworking saw blade tooth , when the choice must be rationalized.